SCI的results部分主要聚焦于实验的客观结果，这些结果是在材料和方法部分中描述的研究或分析所得出的。Results部分为读者建立了后续解释和评估的Discussion部分的基础，以决定这些结果是否足够支持研究假设。
在撰写SCI论文的Results部分时，需要遵循一些写作原则。首先，要按照和引言、方法部分里一样的顺序来对结果进行排序，以避免读者阅读过程中的混乱。所呈现的数据应支持讨论部分中将会提到的所有结论。同时，可以用数据插图（如图表和表格）来替代或取代部分文字，以更直观地展示研究结果。在阐述研究结果时，一般采用过去时，而具体说明结果时则多用现在时。当图表作为主语时，常采用一般现在时，并多以被动语态书写结果。
值得注意的是，Results部分不能包含作者的偏见或对结果的解释，也不能将其置于先前研究的背景中。它应该仅仅呈现实验结果，让读者能够自行判断这些结果的意义和价值。
(data not shown)
(Fig. 1)
(see also Fig. 1)
(see Fig. 1)
(see Figs. 1-3)
according to Fig. 1
as can be seen from/in Fig. I
Figure 1: contains
corresponds (to)
demonstrates
displays
gives
illustrates
lists
as detailed in Fig. I
as evident from/in the figure
as illustrated by Fig. I
as indicated in. Fig. I
as listed in Fig. I
as sho\.vn in Fig. I
as we can see from/in Fig.I ...
can be found in Fig. I
can be identified from/in Fig. I
can be observed in Fig. I
can be seen from/in Figure I
comparingFigs. 1 and 4 shows that. ..
data in Fig. I suggest that . ..
displayed in Fig. I
evidence for this is in Fig. I
from Fig. 1 it can be seen that .. .
inspectionof Fig. I indicates ..
is/are given in Fig. I
is/are represented (etc.) in
is/are visible in Fig. I
in Fig. I we compare/present etc ....
results are given in Fig. I
we observe from Fig. I that ...
plots
presents
provides
reports
represents
reveals
shows
summarizes
·~
应用实例
• The stress data in Fig. I8 indicate a more reasonable relationship.
• Figure 3 illustrates the findings of the spatial time activity modelling.
• The overall volume changes are reported in Fig. 6(d).
• Similar results were found after loading GzmA into the cells (data not shown).
• Typical cyclic voltammograms can be seen in Fig. 1.
• Comparing Figs. 1 and 4 shows that volumetric strains developed after pore pressure had dissipated.
• The rate constants shown in Table 1 demonstrate that the reactivity is much greater at neutral pH.
• The results are summarized in Table 4.
转自小憨憨同学微信公众号，仅作学习交流，如有侵权，请联系本站删除！
